Mike:
I operate my K2 on a 48' St. Francis Catamaran (The Quantum Leap) that I
crew. For an antenna I use a 40 meter center fed dipole fed with 300 twin
lead and terminate it in a LGP 4:1 Balun and run about 20 feet of RG58 to
the K2. I install it as a sloper from the top of the mast by connecting it
to the Spinnaker halyard and pull that end to the top of the mast. (note:
Be sure to attach a downhaul line to the halyard to be safe so that if the
antenna breaks you can still pull the halyard back down and don't have to
climb the mast.) I attach the bottom end of the dipole to the safety
railing on the bow. I use another piece of small line attached to the balun
to keep the twin lead at 90 degrees from the dipole and attach it to the
safety rail at midship. I open a hatch in the salon area and drop the RG58
through and connect it to the rig on the table in the salon. I can take it
down or set it up in about 5 minutes and using the KAT2 in the K2 it tunes
all bands 40 -10 to a 1:1 SWR and receives and radiates very well. The
antenna is made out of a 33' length of AC zip cord that was split and the
insulators are pieces of plexiglass and I use light weight cord on the ends
of the insulators..The whole antenna when coiled up can almost fit in a box
the size of your K1. The center insulator has two 8-32 screws and nuts and
a wing nut on each one so that I can attach the 300 ohm twin lead. The
dipole leads stay attached to the center insulator all the time. By the way
I used this antenna while motoring due to no wind on the way from St. Lucia
to George Town, Bahams and checked into the Maritime Mobile Net running 10
watts and they had no problem hearing me.
73
Jim Younce K4ZM
K2 SN:18
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
