Hi Ken, This effect of gain reduction when NB2 is selected does not happen on my K2. A question is are you receiving large doses of noise that the blanker is removing as the operation of a noise blankers is to cut out the affected section? If the noise is severe enough this can result in distortion and reduction of signal. You can check this by disconnecting the antenna and observing a signal from an RF generator under the same test. Took quite a time before I could even say my NB was even working. Only works with the right kind of noise such as ignition interference. Shades of British Rail and their problems with the wrong kind of leaves on the railway lines! Regards, Bob, G3VVT K2 #4168 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
