On Thu, 30 Dec 2004 05:46:52 EST, [EMAIL PROTECTED] wrote: > Hi Ken, > > This effect of gain reduction when NB2 is selected does not happen on my K2. > > A question is are you receiving large doses of noise that the blanker is > removing as the operation of a noise blankers is to cut out the affected > section? > If the noise is severe enough this can result in distortion and reduction of > signal. > > You can check this by disconnecting the antenna and observing a signal from > an RF generator under the same test. > > Took quite a time before I could even say my NB was even working. Only works > with the right kind of noise such as ignition interference. Shades of > British Rail and their problems with the wrong kind of leaves on the railway > lines! > > Regards, > Bob, G3VVT > K2 #4168 > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com
Hi Ken, No loss of signal when switching in my NB, but it is very selective on what type of noise it blanks. 73 Stewart G3RXQ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
