In a message dated 05/02/05 17:50:03 GMT Standard Time, [EMAIL PROTECTED] writes:
I have noticed an irregularity on my K2 output. When setting the power level a 2 watts, and then using the ATU I get a reading on my SWR/power meter in the line of 4 watts. Setting power on the K2 to 3 watts, I get 4 watts on the in line meter. I thought the meter might be faulty, so replaced it with another with the same result. And the ATU gives me a reading of, say 1.3:1, whereas the SWR/power unit shows 3:1. --------------------------------------------- Try replacing the antenna with with a dummy load and see what the result is then. The external SWR meter will be a voltage reading device and you may be at point where the voltage is higher. Changing to a dummy load should give the correct answer. Bob, G3VVT _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
