Tim, I would venture a good guess that you are actually reading 17.2 millivolts.
If that is the case, check the 4v line out of the thermistor board - pins 6 and 7 (or U6 pin 5 - same line). I would also speculate that you will find the voltage there at 0 volts (ground). Check the back of the thermistor board carefully for solder bridges. 73, Don W3FPR > -----Original Message----- > > I'm finally getting back to working on the K2 after two months of > avoiding re-winding T5. Anyway, it's been rewound and checks out. > I'm now attempting to align the VCO and am having another issue. > > When I connect my DMM to R30, the voltage is 17.2V and no amount of > adjustment on L30 will vary that voltage. Any suggestions? I've > verified L30 and C72. > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
