Gary Scott wrote:
Im building K2 4988,and on Alignment and test part 2 / VCO
alignment, I could not get L30 adjusted to 6 volts on R30, Started
rechecking my work as per directions,everything was fine,so directed
my attention to T5,adjusted the spreadings of T5 and was able to get 6
volts at R30,My question is should I rewind T5 ,or just leave T5 alone
and move on?
If you can get 6 volts at 4 MHz and if all the other band edges are
within range as specified in the manual, then you do not need to rewind
anything, you are all set!
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
