Hi Don
The Hi Cur was not happening before (on CW). I also installed the noise
blanker yesterday and did some CW so I think prior to inserting the
KSB2 it was okay.
The Hi cur only happens on 40m SSB. On CW at full output it varies from
3.3 (on 80 &40) to 2.8 (on the rest of the bands).
So, its only 40m SSB. Sorry about the confusion on the Q2 orientation,
I read that in one of the archive emails. It looks like its installed
correctly to me, in viewing from directly above it.
Any clues?
Neal
On Feb 21, 2005, at 10:26 AM, W3FPR - Don Wilhelm wrote:
Neal,
The Hi-Cur messages are likely not due to the KSB2 installation.
Torubleshoot the Hi-CUR problem first.
The Hi-CUR problem is most likely associated with either the Low Pass
filter, OR a problem with the RF detection and the related transmit
ALC.
Do you get the Hi-CUR warnings at all settings of the Power Control?
Do the
Hi-CUR messages appear on only some bands? Do you get the Hi-CUR
messages
in CW mode, or only in SSB mode? The answer to those questions will
tell
where to begin looking for the problem.
Orientation of Q2 - one side is slightly rounded (or rather the
corners are
'cut off'), and that is the only real way to tell which side is which.
Do
not rely on which side is silver (and contains the labeling) - I
believe
that point is made clear in the K2 manual.
73,
Don W3FPR
-----Original Message-----
I am trying to install the KSBS2 into my K2.
Problem symptoms are that I get the Hi Current warning, plus I get no
variance on my separate receiver when trying the fine balancing.
The rest of the alignment went okay, SSBA on BAL gave me good nulls
with tweaking R1 both on USB and LSB (I just cannot hear any null with
the receiver. I get a very strong carrier (S9+) on my separate
receiver
with SSBA at 3.
Doing the voltage checks on rx, everything looks okay with the
exception of:
U1, pin 22 - 5.6v instead of 0.2
U2, pin 5 - 5.95v instead of 0.6
U3, pin 6 - 1.4v instead of 0
U4, pin 3 - 5.95 instead of 0.6
Since I get the hi cur warning I have not tried any tx voltage
measurements.
I looked at the archives and saw some people put RF board Q2 in
backwards but the 'silver' side is facing the front of the rig.
Any ideas?
N
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
