Ahhhhhhhhhhhhh my English > Jap Geoff! > > I played a bit with my K2 to see if screening of some parts could be done. > The signal path on the bottom of main (RF) PCB is on short paths so putting > the coax lines would not do the job i think (maybe only one trace to TUF > mixer wich is abt 6cm lomg). > The area under control board and DSP where OSC seats is not easily accessible > so i must spend some more time to see if anything can be done. > I am just having fun HI HI.
> > > 73's > Adi > ----- Original Message ----- > From: "Geoffrey Mackenzie-Kennedy" <[EMAIL PROTECTED]> > To: "S55M" <[EMAIL PROTECTED]> > Cc: "Elecraft Discussion List" <[email protected]> > Sent: Tuesday, March 22, 2005 12:21 PM > Subject: Re: [Elecraft] 14361! > > > > Hello Adi, > > > > 14MHz is also the IF for my VHF transverters, but I use another receiver > and > > Tx exciter with them. > > > > When I can I want to shield parts of the K2, but I do not hope for > miracles > > because of the PCB *wires* that would go in and out of shielded areas. To > do > > a proper 100% job would be difficult, so I say to myself STOP, ENOUGH !! > > > > 73, Geoff GM4ESD. > > > > ****************************************************** > > > > Adi S55M wrote: > > > > While surfing arround on Elecraft list archives i read abt 14361 birdie. > > The common statment is "Thanks God is out of band" > > Not if You are using 144/14MHz transverter :( > > > > Adi > > > > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
