And turn off all WINDOWS alterts, sounds when operating AFSK! 73 DE Brian/K3KO
Richard Ferch wrote: > Mike, > > I have not found this to be critical at all, once the audio and VOX levels > are set. First, using manual keying adjust the level out from the sound > card and the LINE input level on the K3 to just get the required 4-5 bars > of ALC. Then increase the K3's MAIN:VOX GN setting until the output from > the sound card triggers the VOX reliably. > > If you also use voice modes with VOX, your VOX GN setting might be > different between voice and data modes. If this is a problem, my > suggestion would be to try changing the gain distribution in the first > step, by increasing the sound card output level and decreasing the K3's > LINE input level. This should allow you to use a lower VOX GN setting. > Just make sure that the sound card level is not set so high that the audio > amplifier inside the sound card is overdriven. > > 73, > Rich VE3KI > > > NF4L wrote: > >> How critical is the match between the K3 and MMTTY for it to >> transmit using VOX. If I key the rig manually, or use DTR it's OK. >> A different program (but using MMTTY) works just fine. > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
