Ohhhhhhh yeah, Been bit by that too. 73, Mike
On 8/8/2010 10:53 AM, Brian Alsop wrote: > And turn off all WINDOWS alterts, sounds when operating AFSK! > > 73 DE Brian/K3KO > > Richard Ferch wrote: >> Mike, >> >> I have not found this to be critical at all, once the audio and VOX levels >> are set. First, using manual keying adjust the level out from the sound >> card and the LINE input level on the K3 to just get the required 4-5 bars >> of ALC. Then increase the K3's MAIN:VOX GN setting until the output from >> the sound card triggers the VOX reliably. >> >> If you also use voice modes with VOX, your VOX GN setting might be >> different between voice and data modes. If this is a problem, my >> suggestion would be to try changing the gain distribution in the first >> step, by increasing the sound card output level and decreasing the K3's >> LINE input level. This should allow you to use a lower VOX GN setting. >> Just make sure that the sound card level is not set so high that the audio >> amplifier inside the sound card is overdriven. >> >> 73, >> Rich VE3KI >> >> >> NF4L wrote: >> >>> How critical is the match between the K3 and MMTTY for it to >>> transmit using VOX. If I key the rig manually, or use DTR it's OK. >>> A different program (but using MMTTY) works just fine. >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
