You should also do a reset of the P3 after the reload of the latest software. Hold the MENU/LABELS key while turning the P3 power on. Hold the button till it says configuration reset. You'll lose your reference calibration and any of your FN labels but this has been known to flush out some of the problems that existed and gives you a clean slate from which to start from with your new firmware.
~Brett (N7MG) On Thu, Aug 12, 2010 at 9:14 AM, Bill W4ZV <[email protected]> wrote: > > > Don Cunningham wrote: >> >> I forgot, in the heat of playing with a new toy, to pass something along >> that may help others. My P3 came loaded with the latest firmware, so I >> was happily using it, and having some strange "issues", like excessive >> display flickering, signals not centered, readout on P3 not matching K3's >> dial, etc. >> > > Some MAJOR firmware fixes were implemented. The first thing anyone should > do after turning on their new K3 or P3 is to load the latest firmware. > Don't be afraid of this...it's very important for best performance and > especially so for a newly introduced product. > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/P3-Firmware-Reload-tp5416645p5416797.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
