Peter ZL1PWD wrote: > > 1/ The bottom cover is quite a tight fit against the RJ connector and I > may take it apart and adjust it with a small file. > > ###Slightly loosen *all* screws in *all* 2D connectors holding the bottom > *and* sides touching the bottom. Try moving the metal and it may snap > into place. Then re-tighten the screws. > > 2/ I will have to check if I have the "I.F. Buffer Gain Mod." installed as > the signals on screen are only visible on very strong ones. > > ###Very easy to check your K3 by removing the front bottom cover only. > Replace 1 SMD or tack solder one leaded resistor in parallel. > > 3/ There is a blemish (photo available) on the front panel metal work in > the cutout around the screen about 7-8mm up from the bottom on the right > hand side.Its like there was a fault in the press that was used to make > the cutout. > > ###I would send your photo to parts at elecraft.com and ask for a > replacement. They will probably tell you to just trash the old one. The > earliest Field Test panels all had to be replaced for another reason. > > 4/ I notice a red light flashing at about 50-60 hz from the underside thru > a join in the steel panels. > > ###This is normal...don't worry about it. > > 73, Bill W4ZV >
-- View this message in context: http://elecraft.365791.n2.nabble.com/P3-33-tp5422602p5422967.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
