Al, The problem that I reported being unable to connect LP_Bridge to the K3 passing through the P3 when it the P3 was powered on seems to be fixed in the P3 V0.31 beta firmware.
Thank you! 73, Ted, W2ZK On 8/7/2010 5:31 PM, Ted Roycraft wrote: > I tried to connect LP_Bridge passing through the P3 to the K3 (the P3 is > supposed to be transparent to apps connecting to the K3 I understand) > and LP_Bridge failed to connect to the K3. Everything is set up to run > at 38400 baud and it worked fine without the P3 there. After fooling > around with it, I found that if I turned the P3 off before starting > LP_Bridge, it would connect to the K3. I could then turn on the P3 and > everything seems to work fine after that. I thought the P3 was > supposed to be transparent as far as RS-232 connections through to the > K3 are concerned but it seems that it isn't. It doesn't seem like a > significant problem since there is an easy workaround but it is a little > annoying. Has anyone else run into this? > > 73, Ted, W2ZK > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
