Hi Part 2
I'm very nearly there thanks to the help given so far. (i) I managed to get through the "6 - Setting Audio Levels" to point 8 on page 46. The next step, adjusting the Balance, has no effect on my ALC levels. Am I right to assume that I can ignore this for the the K3? I've done nothing about the DVK tab as I don't plan on using it just now. (ii) I use Winwarbler in DXLabs for PSK and RTTY. I've set this up for FSK. Should I be using the PSK D and FSK D settings on the K3? (iii) When I run a macro (in Winwarbler) on FSK it puts the K3 into transmit, sends the message and puts the K3 back into receive. However, when on PSK the same macro is sent okay but at the end of the macro the microKeyer 2 clicks but the K3 stays in transmit. What am I doing wrong? Please help Bill GM0VIT -- View this message in context: http://elecraft.365791.n2.nabble.com/K3-microKeyer-2-setup-tp5492196p5498117.html Sent from the [K3] mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
