Dick, try this to set your speed to 4800: Start the K3 Utility. On the Port tab, press "Test communications". The K3 Utility should find the radio at any of the supported speeds. Go to the command tester tab. Type "BR0;" (including the semicolon, but not the quotes) to choose 4800 bps. Go to the port tab and press "Test communications". Hopefully the radio will be at 4800 bps. Press the K3 power button to turn it off. During power-down, the K3 should write the current selected speed to EEPROM for the next power up. Press the K3 power button to turn it back on. Press "test communications". The radio should now be at 4800 bps.
73 de Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Dick Grolleman Sent: Tuesday, September 14, 2010 6:11 AM To: [email protected] Subject: [Elecraft] Setting RS232 baudrate HI ALL Just installed version 4.05 in my K3 to run my P3 as well I always used the microkeyer at 4800 baud from the K3, but I'm not able anymore to set any other speed in the K3 as 38400. Yes I can change it, but the radio does not store it when I leave the menu. And I just can't get it to work on 38400, don't know why. So now my micro keyer is not reading the Radio any solutions? 73 de Dick PA3FQA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
