Thanks Joe and Dick All working agn
73 de Dick ----- Original Message ----- From: "Dick Dievendorff" <[email protected]> To: "'Dick Dievendorff'" <[email protected]>; "'Dick Grolleman'" <[email protected]>; <[email protected]> Sent: Tuesday, September 14, 2010 4:11 PM Subject: RE: [Elecraft] Setting RS232 baudrate >I didn't read your note carefully enough. > > As W4TV correctly points out, the P3 to K3 speed is always 38400. The PC > to > P3 speed can be set to 4800 using the P3 front panel or the BR command. > > Dick, K6KR > > > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Dick Dievendorff > Sent: Tuesday, September 14, 2010 6:22 AM > To: 'Dick Grolleman'; [email protected] > Subject: Re: [Elecraft] Setting RS232 baudrate > > Dick, try this to set your speed to 4800: > > Start the K3 Utility. > On the Port tab, press "Test communications". The K3 Utility should find > the radio at any of the supported speeds. > Go to the command tester tab. Type "BR0;" (including the semicolon, but > not > the quotes) to choose 4800 bps. > Go to the port tab and press "Test communications". Hopefully the radio > will > be at 4800 bps. > Press the K3 power button to turn it off. During power-down, the K3 > should > write the current selected speed to EEPROM for the next power up. > Press the K3 power button to turn it back on. Press "test > communications". > The radio should now be at 4800 bps. > > 73 de Dick, K6KR > > > > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Dick Grolleman > Sent: Tuesday, September 14, 2010 6:11 AM > To: [email protected] > Subject: [Elecraft] Setting RS232 baudrate > > HI ALL > > Just installed version 4.05 in my K3 to run my P3 as well > I always used the microkeyer at 4800 baud from the K3, but I'm not able > anymore to set any other speed in the K3 as 38400. Yes I can change it, > but > the radio does not store it when I leave the menu. And I just can't get it > to work on 38400, don't know why. > > So now my micro keyer is not reading the Radio > any solutions? > > 73 de Dick PA3FQA > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
