Val -- That is good information, but why 38400/N/8/2 ? My manual says the stop-bits should be set to '1' ? Is your keying working with N1MM the way you have it?
73, Tom - W4BQF -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Val Sent: Thursday, September 16, 2010 5:15 AM To: [email protected] Subject: Re: [Elecraft] K3 - CONFIG question Poul-Erik, I have here K3 PTT-KEY as OFF-DTR and N1MM as 38400, N,8,2, DTR-CW, RTS-Always Off. 73 Val LZ1VB >What are the correct settings of the K3 and of N1MM for keying (CW) the K3 >from N1MM? >Sorry if this has been answered in the past - if so pse just a link. >Poul-Erik, OZ4UN ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
