Poul-Erik,
To get N1MM Logger to key my K3, here are my settings that work:
K3: RS232 = 38400
CONFIG:PTT-KEY = rts + dtr
N1MM Config/Hardware
Com 3: Elecraft K3 (in my case)
CW/other checked
SET: 38400/N/8/1
DTR = CW
RTS = Always OFF
This works and follows N1MM CW speed settings up to its max, plus VOX and
PTT still works. Of course if you have other software that you use, then you
have to reconfigure your K3 for that software.
73,
Tom - W4BQF
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Poul Erik Karlshøj
(PKA)
Sent: Thursday, September 16, 2010 4:19 AM
To: [email protected]
Subject: Re: [Elecraft] K3 - CONFIG question
What are the correct settings of the K3 and of N1MM for keying (CW) the K3
from N1MM?
Sorry if this has been answered in the past - if so pse just a link.
Poul-Erik, OZ4UN
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
