Bill W4ZV wrote: > > After physically disconnecting the power plug on the rear of the K3 for at > least 1 minute, connect the serial cable to the K3 only, turn the K3 power > on and then try to run the Utility. >
I probably should have added the following (from Greg AB7R) in place of "turn K3 on and then try to run the Utility" above: > Starting with the power OFF. Turn it ON but HOLD the power button for > about 10 seconds...till you see MCU LD on the LCD. The LCD will not be > lit. This is a forced MCU load state. No using your K3 utility program > in advanced mode, load JUST the MCU file by putting a check just in that > box, nothing else. Then click on send checked items to K3. 73 & GL! Bill -- View this message in context: http://elecraft.365791.n2.nabble.com/New-K3-P3-Beta-Firmware-Available-tp5543809p5545674.html Sent from the [K3] mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
