KAT2 manual. page 15, third checkbox from the top: "Install and solder the 2-pin male connector at P6 on the K2 RF board, as shown by its outline on the right-hand edge. (P6 is labeled AUX RF. Do not confuse P6 with P3, which is labeled AUX 12V.) P6 must be oriented so that its plastic polarizing tab is towards the front panel of the K2."
It's in the KAT2 parts list as RF-P6. Here's a picture of the connector from the Digikey site: http://media.digikey.com/photos/Molex/26-61-4020.jpg?cshift_ck=null&client_id=5042 73 -- Joe KB8AP On Sep 20, 2010, at 7:27 AM, Ian Liston-Smith wrote: > > ... > Well I've looked through the KAT2 manual for info about P6 but not > found any reference. I did a "Find: P6" search on the KAT2 pdf > manual: nothing. > > So... what does this P6 look like and which way should it be > installed? Presumably it's in the KAT2 bag of bits somewhere. > ... > Thanks and regards, > > Ian, G4JQT ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
