P6 should be included with your KAT2 parts. It is listed as RF-P6 in the KAT2 manual and gets installed in the AUX-RF location on the RF board of the K2. It will look similar to the picture in this Digi-key data sheet:
http://parts.digikey.com/1/parts/351741-conn-header-2pos-156-vert-gold-26-61-4020.html Bob, N7XY . On Sep 20, 2010, at 7:27 AM, Ian Liston-Smith wrote: > > I'm slowly working my way through the assembly of my K2 (serial no. 6905) and > got to page 74, "Other Option Component Installation (optional)" near the > bottom of this page. > > It says: "If you have the KAT2 (ATU) [which I have] ... install 2-pin > connector P6. Use the option manual's instructions." > > Well I've looked through the KAT2 manual for info about P6 but not found any > reference. I did a "Find: P6" search on the KAT2 pdf manual: nothing. > > So... what does this P6 look like and which way should it be installed? > Presumably it's in the KAT2 bag of bits somewhere. > > I must be overlooking something obvious, as a search in the list archive did > not reveal anyone else asking this question. > > Thanks and regards, > > Ian, G4JQT > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
