Ross, I think I may have missed the original message. Anyway, if I understand right I would suggest doing a configuration reset. (Hold the MENU/LABELS key wand then hold the POWER key until the Configuration Reset message appears on the screen.) If that doesn't work you might try upgrading P3 firmware. There have been some changes in the way reference level data is saved in EEPROM. The latest version is 00.36.
Alan N1AL On Wed, 2010-09-22 at 13:15 +1200, Ross wrote: > Jim, in his reply stated that the level on the screen should go down to > -150dbm. > As I stated in my email, whenevr I try to change the level, It comes up with > the Boot loader screen, > Not a lot of help. > > Ideas please as I need to lower the noise floor on the P3. > > Thanks > Ross > ZL1WN > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
