Ross the only way I can simulate that behavior on my P3 is by disconnecting the P3 to K3 cable. Doing so causes the bootloader screen to come up immediately when trying to do a ref lvl adjustment. You may have a loose cable or pin not making connection?
Larry K1UO Ross-33 wrote: > > Jim, in his reply stated that the level on the screen should go down to > -150dbm. > As I stated in my email, whenevr I try to change the level, It comes up > with the Boot loader screen, > Not a lot of help. > > Ideas please as I need to lower the noise floor on the P3. > > Thanks > Ross > ZL1WN > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > -- View this message in context: http://elecraft.365791.n2.nabble.com/P3-question-on-the-noise-floor-tp5557268p5558754.html Sent from the [K3] mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
