Currently the K3 Utility's text decode display does not work when the P3 is turned on. That is because it uses the old K3 "TT" (Text to Terminal) command which is not supported by the P3. K3 Utility is going to be modified to support the new "TB" (Buffered Text) command so that it can display text with the P3 connected. (TB actually works better than TT even without the P3.) I'm not sure what the time frame is for that. Perhaps Dick can comment when he returns from vacation.
Alan N1AL On Tue, 2010-10-05 at 12:12 -0500, Oscar Staudt wrote: > When P3 is turned off, I start the K3 Utility, and I will see my text decode > data (both CW and PSK) in the VFO B window, and in the K3 Utility Terminal > window. However, when the P3 is turned on, the data is still shown in the > VFO B window, but does not show up on the K3 Utility Terminal screen. > > K3: 4.112 > P3: 00.36 > > I thought I read something about this on the reflector recently, but I've > been searching and can't find it. I don't remember if this was a firmware > glitch to be fixed, or ...? > > Thanks gang! > > Oscar, WB5GCX > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
