Hi, This is interesting. I don't have this problem whether I have "VFO IND" turned on or not (normally I always have it on but turned it off just to test this. Now, I use an older version of HRD (4.1 build 2321) but I thought the rig control part hadn't changed at all). Also just for the record, I don't double click a DX spot, just a single click will do.
AB2TC - Knut Alan Bloom wrote: > > I finally got HRD set up on a computer connected to the Internet so I > can connect to a DX cluster. I was able to confirm the bug. > > Turns out it has nothing to do with the P3 or the new K3 firmware. It > does it with no P3 connected and K3 version 04.12. Probably older > versions as well although I didn't try them. > > The problem is that in HRD, when you double-click on a DX cluster spot > that is in a different band, HRD sends an FA command to change the K3 > VFO A to the new band/frequency (which is fine) but then for some reason > it sends an FB command to re-set the VFO B to the old band/frequency. > That causes the K3 to do a band change back to the old band. > > A work-around is to go into the K3 CONFIG menu and set VFO IND to YES. > <snip> > -- View this message in context: http://elecraft.365791.n2.nabble.com/K2-LSB-Modulation-issue-tp5621370p5637131.html Sent from the [K2] mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
