Today I decided to download the latest firmware for my P3. Perfect! Then I decided to download the latest K3 firmware. When I ran K3 Utility all seemed to go as usual. When I clicked "Load firmware to K3" the LCD screen on the K3 went out but I could still see MCU LD blinking in the display and the red TX light continued to blink. (The P3 was powered OFF).
Upon investigation, I found that the K3 source folder that I was trying to load from was empty. The download had apparently snuck past me to a different location. Now, the power switch on the K3 will not turn it off. When I remove power from the PS and then reconnect it, the K3 goes right back to an unlit display with MCU LD flashing and the red TX LED blinking. Any ideas on how I can get this K3 working again? Terry, W0FM K3 #474 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
