I also did Lasik, and at my age, I went to the drug store and tested the "reading" glasses that worked best and I found the 2.0 - 2.5 do the job for soldering. I am selling off some used tuners to make room for the T1! Or, perhaps its time to sell serial #35 and build the next unit, just to build again.
Bill K9YEQ -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Craig Rairdin Sent: Wednesday, May 04, 2005 4:39 PM To: 'Elecraft Mail' Subject: RE: [Elecraft] Swing Arm Magnifiers -OT > Since my LASIK, my close up vision has tanked, and before I tackle the K2 > I need a really good swing arm magnifier Skip the fourescent and go for a daylight spectrum bulb in an articulating arm lamp. I use clip on magnifying lenses that clip to my reading glasses. For most a lot of the building activity I can look "under" the magnifying lenses to see through the reading glasses. When I need the magnification it's right there. No problems reading the numbers on those tiny glass diodes. Craig NZ0R K1 #1966 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
