Larry, Does CW transmit work? If so, check the input to KSB2 U1 pin 6 - it should be low with either the closure of the dot paddle or the mic PTT switch.
If it does not go low with either, then you have a connection problem between the Dot line and the KSB2 board input on P1 pin 4, but if it responds to the dot paddle but not the mic PTT switch, you have either a problem with the microphone or the plugging of the microphone configuration header on the front panel board. 73, Don W3FPR On 10/23/2010 5:09 PM, n1szz wrote: > I just purchased a used K2 which was only CW mode only with 100 watts mod, I > assembled and istalled the SSB kit. My problem is I canot xmit. The mic does > not key.. I need some expertise to have my K2 in top notch condition. I need > the K2 gurus that may have some free time to help me. It will probably have > to be shipped and looked at.. HELP.. Larry, N1SZZ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
