Pippo, Put the headers in and bend up two pieces of cutoff leads to stick in the headers rather than soldering the jumpers in.
73, Don W3FPR On 10/25/2010 11:45 AM, Giuseppe Sorrentino wrote: > Hy to all! K2 6995 still on the road...i know i'm a turtle, but i like it that > way! I've just finished the control board and still not placed the jumpers > through J1 and J2 cause just today i received several options from elecraft > and > also the KDSP2. I know that J1 and J2 will be the locations for male pin > headers > to connect the dsp option and i also know that on page 22 of K2 manual is well > written " J1 and J2 (bottom side. These two connectors are provided for an > audio > filter option (KAF2 or KDSP2). An audio filter should NOT be installed until > the > K2 has been completed and tested". Well....but i also understood that when i > will be ready to install the KDSP2 i will have to desolder the jumpers on > J1/J2 > in order to solder the male headers. Now i was thinking: "What about > installing > now the pin headears on J1 and J2 and place the jumpers on the back as usual > together with the pins of headers???" Is it insane as opportunity or not so?? > And if good...i can solder all the pins of the headers for the moment or just > the ones necessary to place the jumpers??? > > Many thanks (hoping have been clear!!!) > IZ2NYY > Giuseppe "Pippo" Sorrentino > Milano ITALY > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
