Tnx Don, so you are saying i can solder all the pin s of the headers without problems?
Pippo IZ2NYY Sent from my IPAD Il giorno 25/ott/2010, alle ore 17.59, Don Wilhelm <[email protected]> ha scritto: Pippo, Put the headers in and bend up two pieces of cutoff leads to stick in the headers rather than soldering the jumpers in. 73, Don W3FPR On 10/25/2010 11:45 AM, Giuseppe Sorrentino wrote: Hy to all! K2 6995 still on the road...i know i'm a turtle, but i like it that way! I've just finished the control board and still not placed the jumpers through J1 and J2 cause just today i received several options from elecraft and also the KDSP2. I know that J1 and J2 will be the locations for male pin headers to connect the dsp option and i also know that on page 22 of K2 manual is well written " J1 and J2 (bottom side. These two connectors are provided for an audio filter option (KAF2 or KDSP2). An audio filter should NOT be installed until the K2 has been completed and tested". Well....but i also understood that when i will be ready to install the KDSP2 i will have to desolder the jumpers on J1/J2 in order to solder the male headers. Now i was thinking: "What about installing now the pin headears on J1 and J2 and place the jumpers on the back as usual together with the pins of headers???" Is it insane as opportunity or not so?? And if good...i can solder all the pins of the headers for the moment or just the ones necessary to place the jumpers??? Many thanks (hoping have been clear!!!) IZ2NYY Giuseppe "Pippo" Sorrentino Milano ITALY ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
