Pedro, Do you have the KXB3080 (or KXB30) option installed? If so, be certain the wires on the top of the option board have been flush cut and the square pads are in place. If the transistors under that board are not down flat against the main board, they will not allow the KXB3080 board to be laid flat and may short to the top cover.
Also check the ground wires on the crystals. If they are not soldered low on the crystal case, they can contact the battery holders and put pressure on the main board when the bottom cover is in place. 73, Don W3FPR On 11/9/2010 11:00 AM, Pedro Correia wrote: > Hi, > > I have a problem with my KX1, I notice that if apply some minor force to the > covers my audio level will vary. This sometimes appends if I tap the main > knob. I did a full soldering rework and still no solution. > Any ideas please. > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
