Don, There was a broken wire from the KXB3080 (G). Also I remade the ground wires on the crystals. It's great now!!
73 Pedro CT2GET > Date: Tue, 9 Nov 2010 11:13:29 -0500 > From: w3...@embarqmail.com > To: pedrocorreia1...@hotmail.com > CC: elecraft@mailman.qth.net > Subject: Re: [Elecraft] KX1 problem > > Pedro, > > Do you have the KXB3080 (or KXB30) option installed? If so, be certain > the wires on the top of the option board have been flush cut and the > square pads are in place. If the transistors under that board are not > down flat against the main board, they will not allow the KXB3080 board > to be laid flat and may short to the top cover. > > Also check the ground wires on the crystals. If they are not soldered > low on the crystal case, they can contact the battery holders and put > pressure on the main board when the bottom cover is in place. > > 73, > Don W3FPR > > On 11/9/2010 11:00 AM, Pedro Correia wrote: > > Hi, > > > > I have a problem with my KX1, I notice that if apply some minor force to > > the covers my audio level will vary. This sometimes appends if I tap the > > main knob. I did a full soldering rework and still no solution. > > Any ideas please. > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html