Mike, How old is this KPA100(does it have red toroid cores or blue ones), and do you have the KDSP2 installed? These may seem like unrelated questions, but actually they are not. A looong time ago (with the older KPA100 T/R switch design) there was a problem with "click on unmute" when the KDSP2 also was installed. The new T/R switch design corrected it.
OK on your wattmeter - if you used a "Larry" calibrated LP100 to set the KPA100 wattmeter, I think it is set right. The LP-100 is one of the few wattmeters I trust. 73, Don W3FPR On 11/24/2010 6:17 AM, VE3WDM wrote: > Good morning Don, The R8 was set to hold but I changed it to normal and tried > the chirp was still there. I then went back to hold and tried again still a > chirp. As you said it is not doing the rig any harm so I will just leave it > as is. The watt meter that I am using is the LP-100A that I built and I had > sent it down to Larry for calibration. Now having said that I meter does go > through 2 LDG antenna switches before the rig. So I am on the weekend going > to remove them and just have the rig and dummy load between the watt meter > and see how it goes from there. > Mike > VE3WDM > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
