Mike, The fact that you have no HiCur warnings working onto a known good dummy load says that the problem is somewhere in your antenna system.
On the "chirp issue", I have no immediate answers. Normally that does not occur with the new T/R switch design (blue toroids). If you had the red core toroids, I would have said the you should try installing KPA100UPKT, but you already have that installed, so I have no guesses for the cause. I would suggest a note to [email protected] to see if anyone else has an idea about the "chirp". 73, Don W3FPR On 11/25/2010 4:11 PM, VE3WDM wrote: > Here is what I did I removed all the coax and coax switches that were in line > with the K2 and dummy load. I also used a better dummy load I did have an > old one from MFJ replaced it with one I got from Ridge. When all that was > done there was no problem on any of the bands with Hi Cur warnings. So > thanks very much for your help with this issue Don. > The other thing about the chirp it is still there and I know you asked me > about the KPA100 and blue toroids. There are 2 of them in the unit and I > checked the date when I purchased the KPA100 from Elecraft and it was > 10/16/2009. You had also wanted to know if the KDSP2 was installed and it > is. Does any of this help with the chirp noise? > Mike > VE3WDM ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
