Just a wild guess, but are your filters enabled for the mode you're using? Using the K3 Utility's Configuration tab, Configure Crystal Filters, check the rows titled "CW Enable", "LSB enable", etc. These allow the filters to be used for receive for the various modes. Your 400 Hz filter needs to be checked for it to be used for receive.
73 de Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of wf4o Sent: Tuesday, December 07, 2010 1:54 PM To: [email protected] Subject: [Elecraft] new firmware release I'm new to the K3 and so my settings may be faulty, buy here goes. I downloaded and installed the latest firmware today without problem. My problem is that when I narrow my width to 0.5 I immediately lose all audio. I have a 400 Hz filter installed. I only regain audio with widening the width greater than 500 Hz and by turning off the AGC. This occurs with or without the APF being engaged. Also with APF engaged and with or without AGC I lose all audio and get strong clicks when adjusting the width and APF. Am I missing something in my setup? -- View this message in context: http://elecraft.365791.n2.nabble.com/new-firmware-release-tp5813395p5813395. html Sent from the [K3] mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
