With 13.0 volts at the input jack (from a bench supply), and 12.7 volts on the circuit board's + bus, I am only reading 1.4 watts maximum power output into a 50 ohm dummy load. I haven't found a problem using the troubleshooting guide, voltages at Q1, Q4, Q5, and Q6 are where they are supposed to be. T1 and L3 look OK to me - but if I'm a sub-par winder can that lead to lower output?
I have the resistors for the higher power output mod, but I'm trying to rule out build problems first. Any additional ideas? Thanks, Chip ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
