David... Thanks for the comment. I was unaware of this. There is a (barely) detectable warmth to the side panel of my K3 with the rig set on a band other than 2 (the rest of it, excepting the front panel, is cool), so you could well be right.
I had hoped that one of the Elecraft Elves would comment on both of my queries. With regard to the power issue, I should have asked Santa for the external xvtr with its higher output. I have found (by measuring) that the TE 1452G is slightly peaked at the FM end of the band, though what one would want with 350 watts in Repeaterville I have no idea. Re-tweaking the TE looks to be the best solution to the drive problem. Again, thanks for your response. Best transition to 2011... John Ragle -- W1ZI ===== On 12/29/2010 2:38 PM, David Pratt wrote: > I am not 100% certain on this, John, but I believe that with K144XV > firmware v1.02, some of its circuits are left switched on when the K3 > is switched to other bands. I think this was in an attempt to reduce > drift. The did not occur with the original v1.00 firmware. > > 73 de David G4DMP > > In a recent message, John Ragle <tpcj1...@crocker.com> writes >> 1. Even when NOT on 2 meters (K144XV off) my K3/100 seems to run hotter >> than prior to installation, e.g. the fans run more frequently. Is this >> general experience? ...and is it simply due to the changes in airflow >> due to the presence of the K144XV structure? ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html