Page 36: Tap 1 to turn ESSB on. Dale W4OP
----- Original Message ----- From: "Bruce McLaughlin" <[email protected]> To: <[email protected]> Sent: Thursday, January 06, 2011 4:47 PM Subject: [Elecraft] K-3 turning on ESSB >I have decided to try ESSB with my K-3. I found the entry TX ESSB in the > config menu and I set it for 3.5. However, the word off appeared at the > left of those figures and it did not change no matter what bandwidth I > set. > I don't know whether that is correct or whether I have managed to put the > radio in ESSB mode. Any suggestions would be very much appreciated. The > owner's manual seems to suggest that the word off should change to on > after > the bandwidth is adjusted. I don't know if that is correct, and if so, > how > I can do that. Rotating the VFO A knob changes the bandwidth but does > nothing to change off to on. Rotating the VFO B knob causes it to go to > another menu entry. Thanks in advance for the help. > > Bruce-W8FU > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html -------------------------------------------------------------------------------- No virus found in this incoming message. Checked by AVG - www.avg.com Version: 9.0.872 / Virus Database: 271.1.1/3363 - Release Date: 01/06/11 02:34:00 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
