Positive. My sound card is a US Interface Navigator. I can turn it's monitor speaker completely off and listen to the K3's monitor.
- Jim WN1X On Jan 8, 2011, at 2:31 PM, "Joe Subich, W4TV" <[email protected]> wrote: > > Are you sure you're hearing the audio from the K3 monitor and > not from other speakers attached to the computer? What sound > card software are you using? Are you sure it is configured to > use the soundcard attached to the radio and not the computer > "default" sound card if you have more than one (e.g., an interface > with built-in sound card)? > > 73, > > ... Joe, W4TV > > On 1/8/2011 2:04 PM, Jim Littlefield wrote: >> Yes, I definitely have the MIC SEL set to LINE IN and the LINE IN gain >> at 30. >> >> >> On 1/8/2011 1:57 PM, John Ragle wrote: >>> Check in particular... >>> >>> MIC SEL = LINE IN >>> >>> also >>> >>> LIN IN set to ~10-30 depending on band... >>> >>> My mic gain runs about "LINE 30" and the SignaLink (IF USING) has TX @ >>> 9 O'Clock and RX @ 11 or 12 O'Clock. (Again, IF USING SignaLink, both >>> jumpers that deal with audio olume are set to the "high" setting...see >>> instructions.) >>> >>> John Ragle -- W1ZI >>> >>> ===== >>> >>> On 1/8/2011 1:47 PM, Jim Littlefield wrote: >>>> Just got my new K3 and everything is great about it except, sound card >>>> data modes (PSK31, etc.) are not working. I put the radio in Data A >>>> mode. When I transmit, the rig is keyed, I can hear audio via the >>>> monitor function, but nothing is transmitted. I have tried cranking the >>>> Mic gain (actually the line in gain) way up, but that doesn't help. I >>>> have also confirmed the transmitter is not in test mode. >>>> >>>> Any suggestions? >>>> >>> >>> >> >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
