Had the same problem in the Fall. Solution (for me) was to download the latest firmware into a fresh directory (no other files), and re-install the latest version of the Utility.
Calibration proceeded normally after that. 73, Kent K9ZTV K3 #21 On 1/9/2011 2:50 PM, Ken K3IU wrote: > Geoff: > > I had this same problem back in mid October 2010 (may still > have it... I just haven't tried to do the RF Cal recently) > and swapped several emails with Dick Dievendorff on the > subject. We came up with nothing and he was going to confer > with Lyle when he got back from vacation. Obviously, this > wasn't at the top of the priority list :-D . > > Dick... any late breaking developments on this issue??? > > 73, > Ken Wagner K3IU > K3 #202 > On 1/9/2011 3:18 PM, Geoffrey Downs wrote: >> This afternoon I performed an RF gain calibration on the main and sub >> receivers using my XG2 and K3 Utility Version 1.3.10.15. All went well. >> >> Then I realised that, contrary to the instructions, I had not turned off >> TEXT DEC. So I turned it off and re-did the RF gain calibration. All went >> well with the main rx but when I started the sub rx calibration a box came >> up headed "RF Gain Calibration Error" and the message in it said "DSP >> command response did not arrive." Tried exiting utility, turning off K3 and >> restarting pc but now the same thing happens every time. K3 f/w 4.22. >> >> Any ideas? >> >> 73 to all >> >> Geoff >> G3UCK > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
