The instructions with the resistance check chart on page 44 of the Rev G KPA100 manual are very explicit about the measurement on J3, namely that the electrolytic capacitor in the 12V line causes this measurement to appear as a short initially, and then slowly go up to a resistance value within range.
I am seeing exactly the same behavior on the Q1 and Q2's collectors and D13's cathode, starts at 0 ohms and ramps up to an in-range value in a number of seconds. Since the instructions were so explicit about J3 and didn't mention these other measurements, I'd like to make sure that this behavior is OK. Thanks - Bruce ----- Bruce Rosen K1FFX -- View this message in context: http://elecraft.365791.n2.nabble.com/KPA100-Page-44-Resistance-Measurements-tp5905235p5905235.html Sent from the [K2] mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
