Bruce, Yes. those points are all connected together by low value resistors or transformer windings.
73, Don W3FPR On 1/9/2011 4:15 PM, K1FFX wrote: > The instructions with the resistance check chart on page 44 of the Rev G > KPA100 manual are very explicit about the measurement on J3, namely that the > electrolytic capacitor in the 12V line causes this measurement to appear as > a short initially, and then slowly go up to a resistance value within range. > > I am seeing exactly the same behavior on the Q1 and Q2's collectors and > D13's cathode, starts at 0 ohms and ramps up to an in-range value in a > number of seconds. Since the instructions were so explicit about J3 and > didn't mention these other measurements, I'd like to make sure that this > behavior is OK. > > Thanks - > > Bruce > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
