Both my K2 (long gone) and my K3 had this issue. I finally just wrapped about 2 turns of vinyl tape around the little rubber bumper on the right side of the tilt-up bail, experimenting with the amount until everyone was happy. My K3 was a factory-assembled unit, and the wobble was NOT because the desktop was bowed. Like Dan, I am using a hard, planar table top. No biggie...
John Ragle -- W1ZI ===== On 1/12/2011 8:49 PM, Dan Grizzard wrote: > My K2 has developed a warping issue. Recently completed and finally totally > assembled the unit does not set flat on the desk or stand. It wobbles. I have > loosened the 3d connector screws, set heavy books on the rig on a marble top > table and then re-tightened the screws. The rig then sits flat with no > wobble. The next morning the warp is back. Has anyone had this issue? ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
