They are complete resets, occurring after MCU, DSP1, DSP2 loads. Note that the K3 goes through exactly the same LED test sequence and timing is the same as a full reset. The only difference between 'normal' and loading resets is that during loading the resets occur during power on.
matt W6NIA On Mon, 07 Feb 2011 08:34:17 -0500, you wrote: >Everyone, >Many times by both the K3 engineers and others it has been stated to recycle >the K3 power after doing a firmware upgrade. I understand the logic behind >this action and do perform a power reset after doing a firmware upgrade or >reload. My question is this. Every time a firmware upgrade is installed there >are several apparent power resets that occur, even after the firmware install >is finished. Am I correct in assuming these apparent power resets are not >complete resets? > >Thanks and 73 >Dave KD1NA >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
