Jim, I thought I saw a post in answer to your comment about QSY in data mode, but perhaps it was an answer in another thread.
The poster said he noticed that when he tapped the knob on the P3 he was rotating it very slightly. After seeing this he said he set one of the function buttons to TAP and his troubles went away. I rarely operate anything but CW here and have noticed the same thing happening to me when I'm on a narrow filters setting below 200Hz. Although I haven't done it yet, I plan to make the change the other poster suggested. I hope this has been helpful. 73, Tom Childers Radio Amateur N5GE Licensed since 1976 QCWA Life Member 35102 ARRL Life Member Retired Professional C# Software developer http://www.n5ge.net On Mon, 7 Feb 2011 11:28:11 +0000, James Balls <[email protected]> wrote: > >Anyone ?????? > >No replies on this ????? > >> From: [email protected] >> To: [email protected] >> Date: Sat, 5 Feb 2011 11:57:34 +0000 >> Subject: [Elecraft] p3 Tap to QSY in Data A mode >> >> All >> >> Just setting up for PSK contest and notice that the tap to QSO is not >> accurate, ie if I tap to qsy to the scope peak for a PSK signal with the >> filters narrow to say 0.2 the signal it well outside the filter pass band >> >> Is there any way of changing this so the signal arrives in the passband in >> DATA A mode? >> >> Thanks >> >> Jim M0CKE [snip] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
