Hi Dohn, On Wed, 2011-02-09 at 14:14 +0000, Dohn Smythe wrote: > It doesn't seem like the VFO center freq on the K3 is making it's way > over to my P3. At the top, in the center, it always read 0.00 for a > freq.
It sounds like there must be something wrong with the RS-232 communications between the P3 and the K3. > The RS232 to RS232 cable is attached firmly and I assume it's > communicating at whatever BAUD the K3 assigns. The K3's serial port is supposed to be set to 38400 baud. It it gets set to something else the P3 is supposed to sense that and change it back to 38400. I would triple-check the cable. It should just work. > Yet, there is NO center freq. listed on the top center of the P3. Another possibility is that the "MENU:Xcvr Sel" on the P3 got set to something other than "K3". Alan N1AL > Any suggestions????? > 73 > Dohn Smythe N8EWY > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
