It's also a good idea to re-tighten to screws periodically but not to over
tighten them.
Ken..G0ORH
Sent from my iPhone
Member of:-
RSGB, NADARS, CDXC, FOC 1684, G-QRP 13178, IPA.
On 1 Mar 2011, at 22:29, K1FFX <[email protected]> wrote:
> A reminder to new KPA100 builders ... the very last step in the KPA100
> construction manual is on page 55 and reminds the builder to go back and
> tighten the screws that hold down Q1 and Q2 after 5 hours of normal use.
>
> I just opened up my K2/100, following the ARRL DX contest, and sure enough
> ... all 4 screws were loose and required the suggested 1/8 turn.
>
> And, as long as I have the top off, I'm seeing if can route the ribbon cable
> more optimally, and will tweak the filter alignment.
>
> Cheers -
>
> Bruce
>
>
>
> -----
> Bruce Rosen
> K1FFX
> k2/100 6982
>
> --
> View this message in context:
> http://elecraft.365791.n2.nabble.com/K2-Loose-screws-on-KPA100-Q1-and-Q2-tp6078966p6078966.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
