Lee, The PC command is both a GET and SET command (see Programmer's reference for syntax), so yes macros can be created to set the power. A process where the "nnn" value would be varied requires some "smarts" in the device sending the macro, Note that the number in the "nnn" value is dependent on the power range, so additional commands may be necessary.
It really sounds like you want more computation than is afforded by only a macro. i.e. Find the power range, change it if required, compute the correct value for "nnn", and then send the PCnnn command. 73, Don W3FPR On 3/12/2011 8:43 AM, Lee Buller wrote: > I have not studied the issue in depth if it can be done, but is there a way to > set a macro to step through power settings on the K3 like between 100 watts > and > 35 watts. Or a macro that sets 25 - 50 - 75 - 100 watts? > > Lee - K0WA > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
