Arnie, Do you have the KXAT1 installed? If you do not, you will have to use a resonant dipole. If you do have the KXAT1, did you do a TUNE on each band before trying it? Did the SWR go down to a sufficiently low number (less than 1.7)?
If the ATU menu parameter is not set for "tun", the KXAT1 will not do any tuning. As others have said, you just may have local noise that is greater than the signal strength. If your KX1 worked and was aligned after you built it, then it should still be properly aligned unless it was abused in some manner. 73, Don W3FPR On 3/12/2011 7:50 PM, arnie lewin wrote: > Dear folks: > > I am using, for the first time, a KX-1. The antenna, as recommended on the > Elecraft FAQ page, is a 24 foot wire and a 16 foot radial. They are > connected to the KX-1 with a BNC to a double banana plug. > > I am on the road from time to time and spend a number of evenings in hotel > rooms. Earlier this week, I fired up the KX-1 for the first time since > purchase. > > I took the 24-foot antenna and dropped it out the 6th floor window. That > gave me about a 2 to 3 foot horizontal run to the window and the remainder > straight down. > > The radial was spread out in the opposite direction along the "dresser" and > then dropping down to the floor for the duration. > > Turning it on, I heard absolutely no signals on 75, 40 or 20. > > Today, I was outside and spread out the antenna and radial in a horizontal > fashion at about a 45 degree angle to each other. > > Signals were heard on 20, but again, nothing on 40 or 75. > > What suggestions do the seasoned KX-1 users have? > > Thank you VERY much > > Arnie > W7BIA > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
