The good thing about this problem... 0 amps at 0 voltage drop :-). Bill K9YEQ K9YEQ K2 and KX1 field tester, K3, P3, K1 and modules
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Robert Harmon Sent: Friday, March 25, 2011 12:45 PM To: Elecraft Reflector Subject: Re: [Elecraft] Anderson Powerpole connector The only problem I have had with the Anderson Powerpoles is from my installing the connectors. I will lose the 12 volts to a piece of gear and it always boils down to the same thing. The leaf didn't snap over the mating piece inside the connector. Looking in at the end of the connector I can see that it didn't slide down completely. If I can't snap it all the way in with my fingers I place the connector vertically on the bench and insert a small flat blade screwdriver and push down on the edge of the leaf until it snaps. Now I always check the connector after assembly to make sure it has snapped in properly. Bob K6UJ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
